#DANTE VIRTUAL SOUNDCARD FREE CODE SOFTWARE#

I've been tracking open source AES67 and axia/livewire implementations for a couple of years now and these are the tools I've found:ДЄn example of a loudness meter/gui, like number 8: Wish 7 : something could be derived from this project : Wishes 6 and 8 : they could also be gathered : it could become a unique discovery/monitoring/routing software, much like AudinateвЂ™s Dante Controller or MergingвЂ™s ANEMAN. I would like to start laying some milestones on this driver, but kernel programming involves a pretty steep learning curve for me :D

I found this github with some guidelines, wrote to the author but did not get an answer yet : (See AudinateвЂ™s Dante Virtual Soundcard, MergingвЂ™s Virtual Audio Device, LawoвЂ™s R3LAY VSC, etc). That way, every need of streaming or recording audio to/from the network is narrowed down to using a simple audio device. Wishes 2, 3, 5, 7, 9, 10, 11 : all these ideas could be gathered in one : we need an AES67 virtual soundcard ALSA module. Wish 4 : I donвЂ™t understand what you mean by a talking clock ?. But all in all, on a fresh latest Debian install, it does not take me more than half an hour to fully configure a master ptp server. Wish 1 : it is actually pretty easy, I will try to draft a tutorial as soon as I have tested every case I can think of. I am an audio engineer and former IT nerd, and I have a LOT of motivation about this. I am very excited to find this wishlist, because I am currently stirring a lot of things related to open-source AES67 support for Linux.

Could you then run jackd without any native audio / kernel support?.

Remote control of the levels of each incoming stream (MQTT?).

Mix together multiple input streams into an output stream.

Allow remote monitoring in GUI / Text console.

Trigger the sending of an MQTT message?.

Monitor the parameters of multicast streams on the network.

Relay multicast/unicast streams from one subnet to another.

Web interface to make remote control/monitoring easy.

with resampling to make the audio match the rest of the network.

Looping (allowing line identification streams).

Play an audio file directly to the network.

A talking clock (based on 'wall clock' PTP time).

Ensure that missing packets don't skew time (replace with silence/repeat previous packet?).

Or write chunked audio (~6 seconds per audio file) to disk, that can then be streamed back using HLS/DASH.

Either write 1 hour audio files to disk.

Long-running Stream recorder / Recording of Transmission archiver.

A guide to setting up a PTP master using Linux + GPS (Raspberry PI + UBlox gps module?).

Please add a comment below if you know of something! The Wishlist It is possible that some of this already exists and I just havn't found it yet.

Hopefully one day it can be turned into a AES67 Awesome List.ДЄs open source has resulted in very rapid evolution of the web, I believe the same is possible for professional/broadcast audio. This is my wishlist of things that would help change that. While Virtual Soundcards enable some of this, native network implementations would allow greater flexibility.

#DANTE VIRTUAL SOUNDCARD FREE CODE SOFTWARE#

Professional audio industries, however there is a very limited amount of open source software available to interoperate with it.ДЄs a result we are often just replacing XLRs with Ethernet, without taking advantage of the possibilites the software give. AES67 (an open standard for high quality audio over IP) is becoming mainstream in the world of broadcast and

Dante virtual soundcard free code